pclab
Moderator
Hi
I have this drive that clicks when power on.
After it goes ready, I can edit headmap in RAM and work with head 1 (head 0 seems dead).
I can read FW and tracks, but can't get it to ID well.
Even after I load 11.rpm.
This is the log:
RAM:
Read HDD Info : ................................: OK
Heads number : .................................: 2
Head map : .....................................: 3
SA Cyl Count : .................................: 64
Serials Mark : .................................: 5816
Control version : ..............................: 31B2
Zone allocation table : ........................: OK
SA SPT : .......................................: 533
ROM:
Read Rom Infos : ...............................: OK
ROM Data Size : ................................: 128 Kb
ROM version : ..................................: 06.BTD
ROM generation : ...............................: 06.BTD
Link table version : ...........................: 01.BC
ROM Firmware version : .........................: 000600BT
ROM Modules:
Switched off heads : ...........................: Yes
Heads number : .................................: 20
Heads number in use : ..........................: 2
heads map : ....................................: 0,1
SA Module Dir Loading...
Load SA Module dir : ...........................: OK
Configuration reading : ........................: Err
It's also ID as a Unicorn - XYZ 5GB drive.
Any chance to access at least one plater surface (I just need a 100mb database which with luck could get it from there)??
What's the next step?
Thanks
I have this drive that clicks when power on.
After it goes ready, I can edit headmap in RAM and work with head 1 (head 0 seems dead).
I can read FW and tracks, but can't get it to ID well.
Even after I load 11.rpm.
This is the log:
RAM:
Read HDD Info : ................................: OK
Heads number : .................................: 2
Head map : .....................................: 3
SA Cyl Count : .................................: 64
Serials Mark : .................................: 5816
Control version : ..............................: 31B2
Zone allocation table : ........................: OK
SA SPT : .......................................: 533
ROM:
Read Rom Infos : ...............................: OK
ROM Data Size : ................................: 128 Kb
ROM version : ..................................: 06.BTD
ROM generation : ...............................: 06.BTD
Link table version : ...........................: 01.BC
ROM Firmware version : .........................: 000600BT
ROM Modules:
Switched off heads : ...........................: Yes
Heads number : .................................: 20
Heads number in use : ..........................: 2
heads map : ....................................: 0,1
SA Module Dir Loading...
Load SA Module dir : ...........................: OK
Configuration reading : ........................: Err
It's also ID as a Unicorn - XYZ 5GB drive.
Any chance to access at least one plater surface (I just need a 100mb database which with luck could get it from there)??
What's the next step?
Thanks