I've got a Toshiba drive here that's clicking. Normally I'd assume bad heads, but I decided to first try backing up the CP so I can later program a new PCB (don't have this one apparently).
I used the normal trick of pressing enter in terminal after powering on, but this one never goes ready. It does return ">" in terminal but then all the status lights just go dead.
Is this common on some models? Or perhaps am I dealing with a PCB issue and not bad heads at all. Any thoughts?
I used the normal trick of pressing enter in terminal after powering on, but this one never goes ready. It does return ">" in terminal but then all the status lights just go dead.
Is this common on some models? Or perhaps am I dealing with a PCB issue and not bad heads at all. Any thoughts?