ST1000LM024 Problem after a fall

Don't Lose Your Data Forever!

DIY data recovery has risks. You could lose your data forever! Don't want to risk it? Talk to a professional now.

adasrip

New member
Hello. I get tired of the ST1000LM024 after a fall.
After head swap hdd stays in bsy. The drive loops and displays constantly on the terminal:

ActiveFW : 00
FWVer : 0001
SATA PLL cal done
DDR size detected = 16MB

DDR size detected = 16MB

*PAUNI_L2958*PA VID=0011 PN=000D Rev=0001- PA_LSI2958 Found
*PAUNI_L2958*PA VID=0011 PN=000D Rev=0001- PA_LSI2958 FoundU
S_0SO_1
SPU@20C,5131mV
IS=1
CLA ..36/76
HO..OK
HO RPM=675 OK
AC 1244
ST..Skip..OK
mS1 00000003
GT:399
SC(L):4118/74
BE.N:21
LDUD..OK : 74
PK_3 C: 0 H:0
GT:400
SC(L):4120/63
BE.N:27
LDUD..OK : 63
PK_3 C: 0 H:1
GT:401
SC(L):4124/54
BE.N:26
LDUD..OK : 54
PK_3 C: 0 H:2
GT:402
SC(L):4125/38
BE.N:24
LDUD..OK : 38
PK_3 C: 0 H:3
GT:403
SC(L):4124/16
BE.N:30
LDUD..OK : 16
PK_3 C: 0 H:0
GT:403
SC(L):4120/39
BE.N:26
LDUD..OK : 39
PK_3 C: 0 H:1
GT:404
SC(L):4125/22
BE.N:25
LDUD..OK : 22
PK_3 C: 0 H:2
GT:404
SC(L):4121/38
BE.N:24
LDUD..OK : 38

Where do you think the problem is?
 

Jared

Administrator
Staff member
Failed read/write heads. That's always the issue after a fall. Pretty much 100% of the time.

Could be damaged platters causing the new heads issues too.
 
Hello. I get tired of the ST1000LM024 after a fall.
After head swap hdd stays in bsy. The drive loops and displays constantly on the terminal:



Where do you think the problem is?
I hate Samsungs this isue. If u get same error after Head swap, weak head or bad sector at SA . Some modules damaged.
OR, drive opened normal place before, not in clean room. Dust sticking head surface. I have experienced this before. Cleaning head helping for a while. Once I have cleaned 5-10 times again and again just for one patient
A new good condition Donor could help also. Good luck
 
Top