So I've got this 2.5" ST500LM000 Kahuna-5400 drive that spins up pretty normally. Makes one slight click (very slight) then goes ready. It correctly ID's but errors out if you try to read a sector or access SA. I notice that in terminal when I press Ctl + Z I get the following response:
However the drive is spinning fine. What does this sound like to you guys, PCB issue? I'm still waiting for a compatible one to arrive so I can rule it out. Just seems really strange to me, I've never seen this before.
Update: I notice too that if I hit Ctl + Z immediately on power on I can get terminal, but still won't let me do anything.
Code:
Rst 0x40M
Servo Processor Is Reset.
(P) SATA Reset
Waiting drive spin up
Waiting drive spin up
Waiting drive spin up
Waiting drive spin up
However the drive is spinning fine. What does this sound like to you guys, PCB issue? I'm still waiting for a compatible one to arrive so I can rule it out. Just seems really strange to me, I've never seen this before.
Update: I notice too that if I hit Ctl + Z immediately on power on I can get terminal, but still won't let me do anything.