Hi
So after changing headmap, I could backup modules from copy 1. From copy 0 and F, nothing...
The drive also started to make noises from heads. So, some must be dead...
I get this LOG:
Loading data for correction of HDD family handling settings from section MEM_P
Selected family......................... : HDx7250GL
Model by ID............................. :
Techno mode key......................... : Ok
NV-RAM reading.......................... : Ok
WARNING! The HDD may be in limited SA access mode at the moment!
NV-RAM reading.......................... : Ok
NV-RAM ID............................... : GM4NG5CÁ
NV-RAM ID............................... : GM4NG5CÁ
NV-RAM ID............................... : GM4NG5CA
NV-RAM data correction................................................ : Ok
NV-RAM writing........................................................ : Ok
Switching SA access................................................... : Ok
Selected family......................... : HDx7250GL
Model by ID............................. :
Selected family......................... : HDx7250GL
Model by ID............................. :
Techno mode key......................... : Ok
Loading modules table................................................. : Ok
Loading the table of "open" modules................................... : Error
Error : .............................................................. : Error executing loading "open" modules dir command
Loading zone allocation table......................................... : Ok
My question is: since I can read copy 1, shouldn't it work with only that copy?
And of course, try to read the much as I can.
Thanks