pclab
Moderator
Hi Guys
I'm having a problem here.
I'm imaging a Shasta drive on which I have cut top head (platter is damaged).
I can ID the drive with loader, etc, etc and access data.
My question is that when imaging head by head, I have tried almost all the options available and the drives get's busy. First it gives me a click, goes busy and stop reading (all blacks).
I have to power off and on, load loader, blah blah blah and start imaging again. I can read about 1GB at a time at about 5mb/s. What option should I select to make it skip that slow or bad sector and continue, without the need of power off, etc, etc?
Have you ever got a situation like this?
I have almost 50% already imaged, and eventually I will manage to do it, but it takes me a lot of babysitting time eheheheh
I'm having a problem here.
I'm imaging a Shasta drive on which I have cut top head (platter is damaged).
I can ID the drive with loader, etc, etc and access data.
My question is that when imaging head by head, I have tried almost all the options available and the drives get's busy. First it gives me a click, goes busy and stop reading (all blacks).
I have to power off and on, load loader, blah blah blah and start imaging again. I can read about 1GB at a time at about 5mb/s. What option should I select to make it skip that slow or bad sector and continue, without the need of power off, etc, etc?
Have you ever got a situation like this?
I have almost 50% already imaged, and eventually I will manage to do it, but it takes me a lot of babysitting time eheheheh