Page 1 of 1

Toshiba Terminal Commands

Posted: Tue May 22, 2018 1:11 pm
by Jared
So I don't currently have much to contribute here, but maybe some others can help turn this into a worthwhile sticky topic. I'll just add the one that I've recently learned and see if more follows.

Toshiba Terminal Commands

Enter Key (Should respond with ">" prompt)
>NVA (disables the NAND flash on SSHDs)
>HP (output list of supported commands)

There's more here on HDD Oracle as well, but given that I've never used them I can't accurately describe what any of them do.
http://www.hddoracle.com/viewtopic.php?f=45&t=751

Toshiba Terminal Commands

Posted: Fri Mar 01, 2019 7:41 am
by DigitalVeriKurtarma
I am using MRT .
There is no terminal window for Toshiba . I used putty. But output data not seeing good. Data output showing only 1 line and writing over that line rapidly
Today i tried to connect Seagate terminal window in MRT. Nice . Seagate terminal working for toshiba drive in MRT

Port setting should be 9600

Toshiba Terminal Commands

Posted: Thu May 02, 2019 8:51 pm
by 300ddr
Jared wrote:So I don't currently have much to contribute here, but maybe some others can help turn this into a worthwhile sticky topic.
I only use Toshiba terminal for pressing "enter" to get drive ready so ROM can be read, try hot-swap, clear g-list/smart, or try reading with utility. The SSHD command may be useful but so far I've always been able to turn this off using utility.