Change parameters (source and destination)

Hi

I need to know if it's possible to change the imaging parameters (source and destination).

For instance: I'm imaging a drive from Sata0 to USB and later I need to connect on Sata1 to continue.

Why I'm asking??
Sometimes while imaging, heads fail and I need to get another donor, so the case stops for a while. After getting the new heads, I want to continue the case, but Sata0 is busy with another case (that could take a few days.
So, how to continue?? I don't want to start a new task.

Thanks

When opening the task, there is a drop-down to change the source channel. If it can't find the destination drive where it expects it to be, it will prompt you to select it from a list.

Thanks Luke

I will check it.