WD40EZRZ-00GXCB0 SED DRIVE LOCKED ERROR

[georgegp]

Model - WD40EZRZ-00GXCB0
ROM Ver - 0002001P

Techno mode key
Techno mode key......................... : Ok

Debug Stop Code reading................. : Status sector reading error Device Error Detected: "VSC ERR VSC CMD SET NOT ENABLED"

RAM:
HDD Info reading........................ : Ok
Heads number............................ : 6
Cyl Count............................... : 256

Zone allocation table................... : Ok
SA SPT.................................. : 2800

ROM:
Read ROM................................ : HDDs ROM reading error Data request error Device Error Detected: "SED DRIVE LOCKED"

Service area:
Permanent overlay....................... : Not loaded
SA dir reading (ID)..................... : SED DRIVE LOCKED
SA dir reading (ABA/CHS)................ : No S/A regions info avalable
SA Access............................... : NONE

Configuration reading................... : Module 02 not found

HDD Identification reading ............. : Ok

Allow module 02 access
Module ID 0B reading error Data request error Device Error Detected: "SED DRIVE LOCKED"

 

[pclab]

You need an unlocked PCB.

 

[pclab]

The information I gave you is wrong (I thought it was a Palmer drive, I didn't check it before).

Try to follow the procedure Ace have on their blog. It's for 2,5" drives, but it might work in your case.
https://blog.acelaboratory.com/pc-3000- ... n-ram.html