New WD, anyone has schematic?

nissimezra

Member
Hi all
I'll try to make it short
I have this new WD. There is power to the pcb but the motor not spinning.
I have 1.8v on the bios chip. It should be 3.3 volts.
Anyone has schematic? please let me know. No, I don't have similar board
EDIT: it is the correct voltage

Thanks in advanced
https://imgur.com/Q5ILhlI
 

Jared

Administrator
Staff member
nissimezra":3ld25rhn said:
[post]13095[/post] Anyone has schematic?

I've never yet in my career seen a schematic for a single HDD PCB. I don't think they make those public or anything.

By the way, you don't have to use imgur here, you can attach pictures directly to the posts.
 

nissimezra

Member
Jared":3uduigmv said:
nissimezra":3uduigmv said:
[post]13095[/post] Anyone has schematic?

I've never yet in my career seen a schematic for a single HDD PCB. I don't think they make those public or anything.

By the way, you don't have to use imgur here, you can attach pictures directly to the posts.
Ok Jared thank you.
I manged to repair the board, one bad resistor.
I think someone opened before 1 screw missing. I loaded the drive once with Raw partition and smart reported no errors.
still no data :(
 
Top