Dear all,
I got one hdd WD32000AAKS-75L9A0 with clicking sound and spindown after the some click. so the following proccess i have done:
1) Block SA Access ...no success
2) disabled head 0 and then spinning is there.
3) Upload Dir into HDD RAM -load from hdd SA and LDR upload
4) after this proccess SA can accessible and ID is like XYZ.... and wrong capacity showd
5) then i took HDD Backup
6)next Module 47 recovery and success
7 write module 47 to ROM modules.
8 then SA translator Regen
9 Re-power and utility restart
Now became capacity and ID is correct and i a can access modules , all modules are perfect
BUT NO SECTOR ACCESS
after that i tried to enable Head 0 in ROm and map editing in RAM like 11-No success also start clicking sound
Also clear and again restore the P-List
Still the drive is showing full ID without able to access a single Sector
expect more advice
Betty
I got one hdd WD32000AAKS-75L9A0 with clicking sound and spindown after the some click. so the following proccess i have done:
1) Block SA Access ...no success
2) disabled head 0 and then spinning is there.
3) Upload Dir into HDD RAM -load from hdd SA and LDR upload
4) after this proccess SA can accessible and ID is like XYZ.... and wrong capacity showd
5) then i took HDD Backup
6)next Module 47 recovery and success
7 write module 47 to ROM modules.
8 then SA translator Regen
9 Re-power and utility restart
Now became capacity and ID is correct and i a can access modules , all modules are perfect
BUT NO SECTOR ACCESS
after that i tried to enable Head 0 in ROm and map editing in RAM like 11-No success also start clicking sound
Also clear and again restore the P-List
Still the drive is showing full ID without able to access a single Sector
expect more advice
Betty