Rosewood ST2000LM007 LED:0x000000BD FAddr:0x00009062

H

harish

Member
Hello sir,
Rosewood ST2000LM007, After selecting Rosewood 8c, family, terminal error, no terminal access, after few minutes hdd get identified, cont.. LED errorI have saved sys files 28,35,93,135. not able to modify Mc, realocation in 93.
[ScrubRemove]!
[ScrubRemove]!
[ScrubRemove]!
[ScrubRemove]!
[ScrubRemove]!
[ScrubRemove]!

(MC POR Duration): 000000D8AD
Intel 6G->3G
Send Status: COMRESET seen
CSpd= 3Gbps
LED:0x000000BD FAddr:0x00009062

LED:0x000000BD FAddr:0x00009062

LED:0x000000BD FAddr:0x00009062

LED:0x000000BD FAddr:0x00009062

Any solution
Harish
 
Jared

Jared

Administrator
Staff member
Why can't you modify System file 93? Is it because it's getting stuck busy or because the changes just aren't happening?
 
H

harish

Member
Hello sir,

Yes sir its stuck busy(status), I can modify 93 file and save, when I check it again by reading from hdd , its all in as its original (No changes).

Thanks

Harish
 
Jared

Jared

Administrator
Staff member
Try writing system file 93 by terminal and power the drive off/on just a few seconds before you send the write. Sometimes it's just getting stuck busy before the write actually happens but you can sneak it in after a power cycle.
 
H

harish

Member
Hello sir,
Just write back sys file 93(removed reallocation read and write, MC) , also trans reg. I have spend more than three days( several attempts). terminal gives only few seconds to write back to hdd.

Thanks
Hatish
 
Jared

Jared

Administrator
Staff member
Yeah, and the translator regeneration was probably unnecessary too. You've got to be careful with that, a lot of these drives have NRG entries.
 
You must log in or register to reply here.
Top