PreampFaultStatus = 0000YW / 0000YWMMMMMM

[Jared]

So here's an error I've never seen before after swapping heads in a Grenada (although I've seen it pop up on forums):

Boot 0x40M
 Spin Up
 RECOV Servo Op=0100 Resp=0005[0x000064AE][0x00006533][0x00006533]ZZZZMMMMMMMMMMMMMMMZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMMddddddW
PreampFaultStatus = 0000YW
PreampFaultStatus = 0000YWMMMMMM

After that, it keeps spinning but stays busy. I'm thinking it's just media damage. This is the third set of replacement heads. First two just clicked away, this one isn't clicking at least.

Any ideas? Obviously, the new heads aren't bad or it'd be clicking away. I'll throw a [glow=green]$ cash reward $[/glow] to anyone who can tell me a way to resolve this one.

 

[Jared]

Already tried replacement PCB... same result.

I do notice that the patient and donor drives used different PCB numbers and the PCBs don't seem to be compatible when I try writing ROM between the numbers. I don't know if that matters though. Both donor and patient were B3 03 preamp code.