st1000lm035

hi to all
i have a sshd 1 tb
this is id ok
user data ok
but after 5sec h.d.d bsy
diagnastic
output terminal :
F3 T>/10

Diagnostic Port Locked

F3 1>
Boot 0x80M
QB
Rst 0x80MSrv DETCR init 0x0000
(P) SATA Reset

RAW OFF
PASS
(DOS Table) Worst Count: 00001328 At SU: 000C5957 NT: 00000005 OT: 00000008
(MC POR Duration): 00000000C2
Intel 6G->3G
Send Status: COMRESET seen
CSpd= 3Gbps
DSC
EDAC Value = 000000000EB7311A
EDAC Value = 000000000EB7311A
Hd 1 Err Blk EB7311E BER pre -1.880434

EDAC Value = 000000000EB7311A
EDAC Value = 000000000EB7311AOut:
LED:0x000000BD FAddr:0x00007845

LED:0x000000BD FAddr:0x00007845

LED:0x000000BD FAddr:0x00007845

Boot 0x80M
QB
Rst 0x80MSrv DETCR init 0x0000
(1Ah)-Serial Port Not Ready
(1Ah)-Serial Port Not Ready
(1Ah)-Serial Port Not Ready
(1Ah)-Serial Port Not Ready
(1Ah)-Serial Port Not Ready
(1Ah)-Serial Port Not Ready
(P) SATA Reset

RAW OFF
PASS
(DOS Table) Worst Count: 00001328 At SU: 000C5957 NT: 00000005 OT: 00000008
(POR) Recover Secondary MCMT Opened Recovered
(MC POR Duration): 000000015B
Intel 6G->3G
Send Status: COMRESET seen
CSpd= 3Gbps


please help
 

Jared

Administrator
Staff member
I know it's not normally an SSHD issue, but have you tried editing ID to disable everything? Perhaps it's something simple like a messed up media cache??? I've been surprised lately at some of the drives where that was the solution, even some older drives that I never thought were prone to this problem.

EDIT: Probably should have asked first, what equipment do you have access to? PC-3000, MRT, or just a TTL adapter?
 

alimeci1

New member
hi
i register in sait yoi
thank you for good sait
i have pc3000 udma-e
access not to madule
and access not EDIT ID
!!! :roll:
 
Dear friends do we hope for this with pc3k udma ?Same case i have drive detects after giving any command which respond to drive port lock message,and than go to the drive id it shows.but try to sa access or lba drive gona busy and must power of or kill the utility option.its like 0093 type problem.Even after waiting some time like 1/2 n hour its directly shows by computer even [device manager],terminal is same.
hoping get some reply from you people.
thnks
 

hddguy

New member
short read channels to allow T> at terminal, edit 0x93 to remove any pending, reallocation and media cache properties, repower hdd

Might be useful to post a log here...
 
Top