I got a 4TB My Passport Drive from WD. That doesn't show any sign of life on the PCB. The USB connector is fine. I soldered a Sata connection to test the PCB. There is 0 amps drawn on 5v rail
I wanted to know if someone could provide me with crucial measuring points, components and voltage...
I got this 4TB WD drive in USB enclosure
Too many bad sectors made it almost impossible to read in USB mode
So i Soldered SATA cable instead
- Unlock ROM and WROTE it back to original PCB through POGO PINS
- Drive Comes Fully Ready
- However after Decrypting the data table wont show up in DE
-...
WDC WD10SPZX-22Z10T1 HDD Constantly dies after swapping Heads
I have this 1 TB Drive in Transcend Enclosure
Model: WD10SPZX-22Z10T1
Serial: WD-WXL2E60FKTS5
Firmware: 04.01A04
Cap: 1TB
When it first come to me it has Head issue. The drive spins up but makes Head clicking sound
I proceed to...
Hi everyone
So i am having this Sandisk 32gb 48mb/s SD card
I used Type 4 Pinout from Acelabs Solbase
Got the card to ID but i think it did not id correctly
It ID: 45 3e 96 93 (64gb)
Which is a 64gb SD
Can anyone check if i got the correct pinout???
Or can someone provide a pinout for me...
I have these 2 drives
1. HITACHI
HTS545025B9A300
250GB
2. HGST
HTS721010A9E630
1TB
They both were having clicking heads
I changed the heads
Upon turning on they got Ready
And as soon as i click into any utility to ID the drives
I got the Abort message
What can be the cause of this problem...
Dead SKHynix NVME SSD Need Recovery
So i got this NVME SSD that died on me recently
I've searched through PC3000 Support and found out that SK controllers haven't been supported yet
I think the only way to recover it is to swap NAND or whatever components that broke on it
I wanted to know if...
Hi,
As the title says. I am willing to buy 2nd Hand SPIDER BOARD for PC3000 FLASH
Because i feel spending 2000 Euros is to much for me but 1000+ is manageable
If anyone have 1 to spare please PM me or send me an email at [email protected]
Thanks!
Can someone check their data base for this particular SD card from Lexar?? SD Lexar 32Gb 800x 120mb/s
Is the card Recoverable??
OR the card has LDPC and ECC??
Some pics
Got an WD250gb with this issue. The drive spins up for 4-5 times then stops. Running the PC3000 UDMA. The status stops on DRD as normal. However when trying to run the utility this happenes. Tried swaping the heads. No avail.
PLS someone help
Techno mode key
Techno mode...