MQ01UBD100 problem

pclab

pclab

Moderator
Hi Guys

Got a case here: I changed PCB on this one (USB to SATA) and could get it to ID and I also saved FW (no noises, nothing).
Opened Data Extractor to start to image, and when I pressed the Headmap button, it started clicking like hell.
After power off, it never worked again... Spins up, no click, but always busy....

Did anyone got a problem like this??
 
Amarbir[CDR-Labs]

Amarbir[CDR-Labs]

Member
Well,
Remove PCB ,Give Power Wait for Sometimes For It To Get Ready ,If Not Ready Give Soft Reset Still Nothing Give Hard Reset ,Once Ready Give Sleep Command ,Once That is Done Put PCB Back To HDA ,Once That is Done Start Motor " Recalibrate " , Try To ID ,Revert Back On Forum With Your Case Status
 
You must log in or register to reply here.
Top