Recent content by polykyle

Sorry for the delay, but yes the ROM chip does get hot on the pcb when power is being sent to it. Any thoughts? Thank you.

Thank you Sam, I'll take the pcb to our electronics lab here and take a look. I'll check the joints for any breaks or weaks spots.

The motor controller that you can't read from the pictures is 3cathktrg4 / tls2605. The bottom numbers match each chip. I'll see if I can't find a different revision though - thank you Jared. Sorry, do you mean all the solder points in contact with the ROM chip? Just wanted to make sure as...

Thank you Jared, I'm attaching photos of each. The picture missing the ROM chip is the 100760718 board. The pcb 100760718 chip reads: Winband 20x40cl05, 1542, 6530, 2c000zs. Thank you.

Sorry, yes you are correct Jared.

Greetings all, I have a 10076718 pcb board and the students usb 3.0 micro b connector is directly into the board and the student broke it. I purchased a replacement pcb 10072903 with a SATA connection as it is compatible per this forum (thank you!). I just finished transferring the firmware chip...

Greetings all, I have a 10076718 pcb board and the students usb 3.0 micro b connector is directly into the board and the student broke it. I purchased a replacement pcb 10072903 with a SATA connection as it is compatible. I just finished transferring the firmware chip but the hard drive wont...