Recent content by Navafigo

Hi , i have this model with error sed. When I try to take the step of "upload dir into HDD RAM" i can't execute it because i get this error. Any idea?

Hi again, my problem was the reading speed of the rom the speeds 6 000 000 b / s, and 921 600 gave error. With 38400 perfect. The HD is ok. Thanks so mucho guys

Hi, I have a SEAGATE model ST1000LM035 with FW SBM3. It has the "Diagnostic Port Locked" error. I looked at the guide of Unlocking the Rosewood Drives (http://blog.acelaboratory.com/pc-3000-for-hdd-seagate-f3-unlocking-the-rosewood-drives.html) When I press ok, this error appears (photo). I...

Thank you so much. Finally a forum where information is shared and not hidden. ;)

No, I don't have an external programmer to read it, but maybe you can recommend one to me

Yes, I can see the data but I can not write data on it. By data I mean 'personal' data like photos, videos, etc. Other issue is that the PC3000 is not able to read the family when I try to open the WD utility (that's when the SED DRIVE LOCKED error appears )

Hello! I have this model, when I try to detect the family I get the message "SED DRIVE LOCKED" The disc works well, I can see videos and photos but it does not let me copy data What family is that? The error "sed drive locked" is similar to the famous SED DRIVE LOKED of the 2.5 "? Thanks

Thank you for all your answers. This work came manipulated from another laboratory. I have tried all the variants and the result was negative

As Bios I mean the chip circled in the attached Photo. I can't read anything from de original PCB because it doesn't work. I tried the patient's bios with the donor PCB, and it doesn't work. I also tried the donor Bios with the Patient PCB, getting the same result. Before that Itried the donor...

With the pcb of the donor without putting the bios of the original I stay like this.

I have this hard disk model but the board does not work or is detected. I have a donor with the same characteristics, but when I put the bios of the original, it still does not detect anything. Is there any way to get the rom modules out of the original? How is your safe mode?

Thank you so much Jol, i will try.

When I try to load an ldr with the same characteristics it gives error.

Hi Would you please give me a piece of advice about a WD20EARX 00PASB0. The drive seems to work well, it pass the BSY state and there is no strange sound, but when I try to open the WD utility, it doesn't recognise the Drive's ID (both normal and kernel mode) .

Thanks Jol, this is the HD