User avatar
pclab
Forum Moderator
Posts: 1675
Joined: Tue Jan 13, 2015 4:55 pm
Contact: Website Facebook

Change parameters (source and destination)

Mon Mar 06, 2017 12:14 pm

Hi

I need to know if it's possible to change the imaging parameters (source and destination).

For instance: I'm imaging a drive from Sata0 to USB and later I need to connect on Sata1 to continue.

Why I'm asking??
Sometimes while imaging, heads fail and I need to get another donor, so the case stops for a while. After getting the new heads, I want to continue the case, but Sata0 is busy with another case (that could take a few days.
So, how to continue?? I don't want to start a new task.

Thanks
www.pclab.com.pt
facebook.com/PCLAB.Assistencia.Tecnica

User avatar
lcoughey
Forum Moderator
Posts: 632
Joined: Mon Jan 12, 2015 12:46 pm
Location: Ontario, Canada
Contact: Website Facebook Twitter Google+

Change parameters (source and destination)

Mon Mar 06, 2017 1:07 pm

When opening the task, there is a drop-down to change the source channel. If it can't find the destination drive where it expects it to be, it will prompt you to select it from a list.

User avatar
pclab
Forum Moderator
Posts: 1675
Joined: Tue Jan 13, 2015 4:55 pm
Contact: Website Facebook

Change parameters (source and destination)

Mon Mar 06, 2017 1:44 pm

Thanks Luke

I will check it.
www.pclab.com.pt
facebook.com/PCLAB.Assistencia.Tecnica

Return to “PC-3000 Forum”

Who is online

Users browsing this forum: No registered users and 0 guests