That Hakko station should work fine, just be sure you're buying the full station, not just the iron (which won't work by itself). That link is only to an iron, not a full station.
However, for removing/replacing parts like that, hot air rework might work better. It's pretty hard to remove 8+ contact points all at once with an iron. Hot air is much easier for the removal part of the process.
For the cost of a simple Hakko station, you can get a setup like this from a cheaper brand like Aoyue: https://www.ebay.com/itm/Aoyue-866-Sold ... :rk:3:pf:0
If you want to get into the really small stuff, like iphone board repair, then you might need a smaller iron like the Hakko, but just for HDD PCB stuff an Aoyue station with some 900M-T-1C tips is usually small enough to work.